HPE Aruba Networking AP-MNT-D Campus AP Type D Solid Surface Mount Bracket Kit

AIR-AP-BRACKET-2=

ETH-SP-G2

WG9004

RBKWM-10000S

UACC-LITE-AP-AM

The AIR-AP-BRACKET-2 wall/ceiling mount is used to mount a Cisco Aironet 1040, 1140, 1260, 3500 or 3600 series access points. Note: This is a non low profile option. The wall/ceiling base is included with the necessary screws for installation. We proudly offer a compatibility guarantee and lifetime warranty for risk free purchasing.

ESD Protection for Outdoor High-Speed Networks

Introducing the Ethernet Surge Protector, model ETH-SP, from Ubiquiti Networks. The ETH-SP is a cost-effective solution for protecting outdoor Ethernet devices from damaging electrostatic discharge and surges. Since all Ubiquiti® airMAX® devices already have robust ESD protection built in, adding the ETH-SP to the installation provides an additional layer of protection to the network.

The ETH-SP is engineered to protect Power-over-Ethernet (PoE) or non-PoE devices with connection speeds of up to 1 Gbps. Two passive, surge-protected RJ45 connections provide maximum equipment
compatibility.

Ideal for WISP Networks
All Ubiquiti airMAX devices are equipped with ESD protection. However, to protect outdoor devices, and to meet certain local code requirements, installing the ETH-SP is essential.

For example, to guard against costly service calls, and to help your subscriber installations meet code requirements, install two ETH-SPs: one near the CPE, and the other at the entry point to the building.
Damaging ESD attacks and surges will be absorbed by the ETH-SPs and safely
discharged into the ground.

WatchGuard Dual-Band Omni Antennas (5/7 dBi) AP430CR/AP327X

Get More for Your Orbi WiFi Systems Accessories
Orbi accessories enhance your WiFi experience for your home or business. Designed to compliment Orbi desktop WiFi systems.

Wall Mount Kit
The Orbi Wall Mount Kit takes your WiFi strength and aesthetic a step further while also mounting and stabilizing your desktop Orbi units onto almost any vertical surface. This easy-to-install mounting kit lets you experience less signal interference while avoiding tip-overs or water damage from spills.

Wall mount for an UniFi6 Lite, nanoHD, or AC Lite. The Access Point Lite Arm Mount (UACC Lite AP AM) allows you to mount an UniFi6 Lite (U6 Lite), nanoHD (UAP nanoHD), or AC Lite (UAP AC Lite) to the wall instead of the ceiling.

Cisco Aironet Original Mounting Bracket for Wireless Access Point

Ethernet Surge Protector Gen 2, Surge Voltage from 100V/s to 1kV/µs, IEEE 802.3af PoE Support

Dual-Band Omni Antennas (5/7 dBi)

Wall Mount Kit, 145x84x21 mm

Arm Mount, Plastic

Cisco

Ubiquiti

WatchGuard

NETGEAR

Ubiquiti